Table 1-46 Caller Id Sent To Mobile Telephone - NEC SL1000 Features And Specifications Manual

ISSUE 2.0
* Only when the outbound trunks are ISDN or SIP trunks.
** ISDN will need to accept the inbound Caller ID as the Calling Party Number (CPN) presentation for
the outbound call.
Inbound Trunk
Analog CID
Analog CID
ISDN PRI
ISDN PRI
Analog CID
Analog CID
ISDN PRI
ISDN PRI
Conditions
• If the extension has Call Forward-Both Ring set to another extension, it will only continue to forward
if the Both ring location is forwarded (B/NA or NA) to VM and no where else.
• Analog, ISDN and SIP trunks are supported for the outbound call to the Mobile Extension.
• It is recommended that this feature uses ISDN platform (as these trunks provide answer
supervision).
• The analog line must provide CLI information to allow the Mobile Extension to dial into the system to
access features.
• For the extension DTMF, the minimum Detect Level for the DTMF Tone (PRG 80-03-03) must be
set to allow a minimum detection level of -25dBm. This entry is dependent on the Detect Level
selected in PRG 80-03-01.
• The Mobile Extension uses the
be changed (PRG 11-10, PRG 11-11, PRG 11-12, PRG 11-13).
• To provide a proper disconnect, Disconnect Supervision is required for the trunks used for this
feature.
• When an entry is made in PRG 15-22-01 for a Mobile Extension, ports are reserved for Mobile
Extension usage in groups of 4.
• To keep consecutive port numbering for units, you may wish to consider starting Mobile Extensions
at the upper extension port range.
• Calls on Mobile Extension can be easily picked up from a telephone in the system. This is done via
a Barge-In key (34+Mobile Ext # or 34+
Ring is set to. If no Forward Both Ring is set, the key will act as a basic Barge-In key.
• If the main terminal has call forward both ring set to the Mobile Extension and the Ecology-Power
Cutting feature removes power to the terminal any calls sent to the terminal will not go to the Mobile
Extension.
Default Settings
No Mobile Extensions are configured.
Features and Specifications Manual

Table 1-46 Caller ID Sent to Mobile Telephone

Outbound Trunk
CFA Analog
CFA ISDN PRI/SIP
CFA ISDN PRI/SIP
CFA Analog
CFNA Analog
CFNA ISDN PRI/SIP
CFNA ISDN PRI/SIP
CFNA Analog
* to perform a flash, so any service codes which begin with
* *
) will Barge-In to the Extension that Call Forward Both
SL1000/SL1100
Y/N
N
Y
Y
N
N
M
Y
Y
N
* must
1-489