Table of Contents
Advertisement
Chapter 3
3.1 Operations after POST Screen
After CMOS discharge or BIOS flashing operation, the system will display the following screen for your
further operation. Press F2 key to continue or F1 key to enter CMOS Setup.
AMIBIOS©
BIOS Date: 03/22/12 15:57:19 Ver: 08.00.16
CPU : Intel® Atom™ CPU D525
Speed : 1.80 GHz
Press F11 for BBS POPUP
Initializing USB Controllers. . Done.
2038MB OK
Auto-Detecting Pri Master.. IDE Hard Disk
Pri Master : Hitachi HTS545016B9A300 PB0C64G
Ultra DMA – 5, S.M.A.R.T. Capable and Status OK
Auto – detecting USB Mass Storage Devices ..
00 USB Mass storage devices found and configured
CMOS Settings Wrong
CMOS Data / Time Not Set
Press F1 to Run SETUP
Press F2 to load default values and continue
After optimizing and exiting CMOS Setup, the POST screen displayed for the first time is as follows
and includes basic information on BIOS, CPU, memory, and storage devices.
AMIBIOS©
BIOS Date: 03/22/12 15:57:19 Ver: 08.00.16
CPU : Intel® Atom™ CPU D525
Speed : 1.80 GHz
Press DEL to Run Setup
Press F11 for BBS POPUP
Initializing USB Controllers. . Done.
2038MB OK
Auto-Detecting Pri Master.. IDE Hard Disk
Pri Master : Hitachi HTS545016B9A300 PB0C64G
Auto – detecting USB Mass Storage Devices ..
00 USB Mass storage devices found and configured.
Checking NVRAM..
Press F11 key to enter Boot Menu during POST, as shown by the following figure.
2009 American Mega trends , Inc.
2009 American Mega trends , Inc.
@ 1.80GHz
Ultra DMA – 5, S.M.A.R.T. Capable and Status OK
@ 1.80GHz
BIOS Setup
0085
0085
Advertisement
Table of Contents
