Checking The System Is Upgraded; Preparing A Point To Multi-Point Meeting; Setting Up The Mcu Setup Menu - Sony PCS-1500 Service Manual

Checking the System Is Upgraded

3
Check that the system has been
properly upgraded as follow the steps
below.
Also, check that the serial number
sticker is placed on the bottom of the
Compact Processor.
If the sticker is not placed, consult
4
your Sony dealer.
1
Press the MENU button on the
Remote Commander.
The Menu (System Configuration)
Notes
menu appears on the monitor
screen. • Upgrade operation is only for
Menu System Configuration
• This card can be installed only once.
CONTROL SETUP
CAMERA ISDN
T. 120 ANSWER
STATUS AUDIO
COMMUNICATION MCU
MACHINE OTHER
SELECT: END: CANCEL
2
Select MACHINE with the joy
stick on the Remote Commander,
then press the stick.
The Machine Information menu
appears on the monitor screen.
Machine Information
HOST VERSION: VerX.XX
BRI VERSION: VerX.XX
VCP VERSION: VerX.XX
DSP VERSION: VerX.XX
Software Option :MCU
Option Board :2BRI
Exit: CANCEL
16
Check that Software Option is set
to MCU.
When it is set to MCU, upgrade is
completed. If it is not set to MCU,
consult your Sony dealer.
Press the CANCEL button on the
Remote Commander twice.
The menu disappears from the
monitor screen.
qualified personnel.
The card which has been already
installed into another Compact
Processor cannot be used.
Installed functions cannot be
removed.
Preparing a Point to Multi-Point
Meeting
Set up the MCU SETUP menu before
4
holding a point to multi-point meeting.
Setting Up the MCU
SETUP Menu
5
1
Press the MENU button on the
Remote Commander.
The Menu (System Configuration)
To hold a normal conference
menu appears on the monitor
Set MCU MODE to OFF in step 3.
screen.
2
Select MCU with the joy stick,
then press the stick.
On items in the MCU SETUP
menu
The MCU SETUP menu appears
The settings for the MCU SETUP
on the monitor screen.
menu are as follows:
MCU SETUP
MCU MODE
MCU MODE :ON
BROADCAST MODE :4 SPLIT
NUMBER OF LINES :2B
ISDN RATE :AUTO
AUDIO MODE :G. 728
BROADCAST MODE
SELECT: Save? Yes: EXEC No: CANCEL
3
Set up the following items:
MCU MODE: Set to ON when
holding a point to multi-point
meeting.
You can also switch the broadcast
BROADCAST MODE: Selects
mode during a meeting with the
the broadcast mode.
MULTI/AUTO button on the Remote
NUMBER OF LINES: Selects
Commander.
the number of lines to be used.
ISDN RATE: Selects the transfer
For details on switching the broadcast
rate.
mode, see "Switching the Broadcast
AUDIO MODE: Selects the
Mode" on page 21.
protocol for the audio
encoding.
Press the EXEC button on the
Remote Commander.
The settings are completed.
Press the CANCEL button on the
Remote Commander.
The menu disappears from the
monitor screen.
ON: Holds a Point to multi-point
meeting.
OFF: Holds a normal meeting.
4SPLIT: Displays each party on the
four-split screen.
VOICE ACTIVATE: Detects the
terminal that speaks at the highest
level among the connected
terminals, and sends the picture
to all the terminals.
17