On Screen Messages - Sony PCS-1500 Service Manual

5-1. On Screen Messages

The following messages appear on the TV monitor when using the Compact Processor and gives instruc-
tions on dealing with them.
Message
INCORRECT DIALING SETUP
CANNOT COMPLETE CONNECTION
(The following code and message appear.)
0 Unknown network error
1 Number does not exist
2, 3, 6 Network congestion
16 Normal disconnection
17 Line is busy
18 System not responding
19 No answer from user
21 Call rejected by network
22 Called party number changed
26 Non-selected user clearing
27 Remote system out of order
28 Invalid number entered
31, 34, 41 – 44, 47 Network not available
50 Not Subscribed
57, 58 Bearer capability not authorized
70 Line Rate Error
88 Incompatible equipment on remote site
91, 95 – 102, 111 Local system out of order
128 H.221 Negotiation timeout
131 Hardware failure
132 SPID registration incompatible
144 Bonding Negotiation timeout
145 Bonding Negotiation failed
FAR END INACTIVE
PLEASE CLOSE THIS MENU
CANNOT ESTABLISH
ALL CONNECTIONS
CONFIGURATION ERROR
Command is rejected by MCU
CORRUPTIVE DATA STREAM.
TERMINATE THE CONNECTION
PLEASE INPUT TITLE
PCS-1500/1500P
Section 5
On Screen Messages
Remedy
Make sure the selected entry is correctly registered.
Please try again later.
Please check the number and try again.
Please try again later.
(Normal disconnect)
Please try again later.
Please check if remote system is connected.
Please check if other party is present.
Please check access restrictions remote site.
Please check the number and try again.
Please try again later.
Please contact remote party.
Please check the number and try again.
Please try again later.
Please check the remote party's facility subscription.
Check if the line rate is set correctly.
Please check if the line rate is set to correctly.
Please check if remote party has compatible system.
Restart system and try again.
Power off and power on.
Check the line interface boards.
Please register SPID.
Power off and power on.
Power off and power on.
The remote party operates the menu.
Close the menu.
Check to see if your partner's telephone number is the correct
one.
Wait for a while and then try dialing again.
The function is not supported for MCU if the same operation
displays this message again.
A signal error occurred. The line connections are compelled to be
disconnected.
Input an index title.
5-1