When The Power Is First Turned On After Installation - Sony PCS-G70 Integration Manual

1-4-3. When the Power is First Turned On
after Installation
Turning On
Turn on the communication terminal in the following
procedure.
1. Turn on the TV monitor.
If the IR repeater is installed in the TV monitor, set the
TV monitor to standby mode. The TV monitor will
turn on simultaneously when the communication
terminal is turned on.
2. Turn on the power of any other equipment to be used
for the videoconference.
3. Set the power switch on the right side of the communi-
cation terminal to the on position ( ).
POWER indicators
(Light green.)
The communication terminal turns on after a while. Three
indicators on the front of the communication terminal and
the POWER indicator on the camera light, then only the
POWER indicators on both units remain on in green.
m
. After the power is turned on, the camera unit moves
automatically for trial operation. Be careful not to catch
your finger.
. If the camera is obstructed forcefully while it is moving,
it may not resume moving or output a signal to the
communication terminal. In this case, turn off the
terminal, and turn it on again.
. A Sony TV monitor may not turn on if the "IR Repeater
Mode" setting does not meet the TV monitor specifica-
tions. In this case, turn on the TV monitor manually or
by using its remote controller, perform the setup wizard
of the communication terminal, and then change the "IR
Repeater Mode" setting in the General Setup menu.
PCS-G70/G70P
Power switch
Setting Up the System for the First Time — Initial
Setup Wizard
When the power is first turned on after installation, the
wizard for initialization is displayed if self-diagnosis is
completed. Register according to the wizard.
The items set according to the wizard can also be later
changed on the menu screen.
m
. The wizard for initialization is also displayed when the
ISDN unit is newly installed after system installation.
Similarly, register according to the wizard in this case.
. When the communication terminal and the camera are
separately installed, point the remote commander to the
camera unit for operations.
1. Use the or button on the remote controller to
select the language displayed in the menus or messag-
es.
Language:
Select one of the desired language from English,
French, German, Japanese, Spanish, Italian, Simplified
Chinese, Portuguese, and Korean
* Korean is added by upgrading.
Language English
2. Select "Next" using the , , , or
remote commander, then press the PUSH ENTER
button.
The Monitor Setup Wizard is displayed.
n
The monitor setting wizard is set when two or more
monitors are connected to the system. When only one
monitor television is connected, select "Next" and
proceed to step 5.
*
.
button on the
1-9