Sony PCS-1500 Service Manual page 82

2-5. Replacing the Main Parts
5. Unlock the four claws of the microphone box upper
assembly from the bottom of the microphone box.
6. Remove the microphone from the bottom of the
microphone box.
7. Remove the microphone retainer from the microphone.
8. Attach the new microphone by reversing the disassem-
bling procedure of steps 1 to 7.
n
Standard tightening torque : 80 x 10
Precaution for installation of the microphone
Be careful of the followings when fixing the harness using
the harness retainer as shown.
1. Be cause the built-in microphone is a high sensitivity
microphone, the microphone can pick up vibrations of
the PCS-1500/1500P via microphone harness.
Be sure to give a small amount of play to the micro-
phone harness when fixing the harness with the
harness retainer.
2. The camera connection connector as shown is fixed
with some play in order that the connector can be
easily connected to the camera block.
Adjust the harness retainer after the harness is fixed
with the harness retainer, so that the camera connect-
ing connector becomes level.
2-6
_2
N.m {8 kgf.cm}
Claws
Microphone box
upper assembly
Microphone
Microphone
retainer
Microphone box
lower
Camera connection
Harness retainer
connector
Level
Camera connection
connector
Harness Harness retainer
Microphone
assembly
Upper cabinet
Microphone
harness
PCS-1500/1500P