On Screen Messages - Sony PCS-1600 Operating Instructions Manual

On Screen Messages

The following messages appear on the TV monitor when using
the Compact Processor and give instructions on dealing with
them.
Message
Incorrect dialing setup.
CANNOT COMPLETE CONNECTION
(The following code and message
appear.)
0 Unknown network error:
1 Number does not exist:
2,3,6 Network congestion:
16 Normal disconnection:
17 Line is busy:
18,19 System not responding:
21 Call rejected:
22 Called party number changed:
26 Connection restoration request:
27 Remote system out of order:
28 Invalid number entered:
31, 34, 41 – 44, 47
Network not available:
50 Not a Subscriber:
57,58 Bearer capability not
authorized:
70 Restricted capability:
88 Terminal attribute error:
91, 95 – 102, 111
Protocol error:
128 H.221 negotiation timeout:
131 Board mismatch:
132 Invalid SPID:
134 Physical link synchronization
error:
144, 145
Bonding negotiation timeout:
Remedy
Make sure the selected entry is correctly
registered.
—
Try again later.
Check the number and try again.
Try again later.
(The line has been disconnected normally.)
Try again later.
Check if the remote system is connected.
Check if the remote system is connected.
Check the number and try again.
Try again later.
Check if the remote system is operational.
Check the number and try again.
Try again later.
Check the remote party's facility contract.
Check if the line rate is set correctly.
Set the line rate to 56K and try again.
Check the connection of the remote system.
Turn off and restart the system and try again.
Turn off and restart the system and try again.
Check the optional line interface boards.
Reregister the SPID.
Check the connection of the ISDN cable.
Turn off and restart the system and try again.
(Continued)
155
Appendix