On-Screen Messages - Sony IPELA PCS-G50 Operating Instructions Manual

On-screen Messages

Check the following if a message appears on the TV monitor when operating
the Communication Terminal.
Message
Incorrect dialing setup.
CANNOT COMPLETE CONNECTION
(The following code and message appear.)
0 Unknown network error:
1 Number does not exist:
2,3,6 Network congestion:
16 Normal disconnection:
17 Line is busy:
18,19 System not responding:
20 No such subscriber
21 Call rejected:
22 Called party number changed:
26 Connection restoration request:
27 Remote system out of order:
28 Invalid number entered:
31, 34, 41 – 44, 47
Network not available:
50 Not a Subscriber:
57,58 Bearer capability not authorized:
70 Restricted capability:
88 Terminal attribute error:
91, 95 – 102, 111
Protocol error:
128 H.221 negotiation timeout:
132 Invalid SPID:
134 Physical link synchronization
error:
144, 145
Bonding negotiation timeout:
177 LAN connection timeout:
178 LAN connection rejected:
179 DNS error:
218
On-screen Messages
Meaning
Make sure the selected entry is correctly registered.
—
Try again later.
Check the number and try again.
Try again later.
(The line has been disconnected normally.)
Try again later.
Check if the remote system is connected.
Confirm the site number.
Check if the remote system is connected.
Check the number and try again.
Try again later.
Check if the remote system is operational.
Check the number and try again.
Try again later.
Check the remote party's facility contract.
Check if "Restrict" is set correctly.
Set "Restrict" to "56K" and try again.
Check the connection of the remote system.
Turn off and restart the system and try again.
Turn off and restart the system and try again.
Reregister the SPID.
Check the connection of the ISDN cable.
Turn off and restart the system and try again.
Try again later.
Try again later.
Please check DNS.