Selection Of Actuator Type (Function) - Siemens TXP-CLC Manual

Parameters (set the operation of the block)
Function Selector MOT/SOV/BKR
PBR Command output priority
BAV Command output variant
TUM Maximum under voltage time
TWS Timed sequence re-closure
RWE Feed back travel limit switch on
RWA Feed back travel limit switch off
TVE Time to leave limit position
TGL Running time
WRBHAEA Cb. Er. Bl. N.man/auto on/open
WRBHAAZ Cb. Er. Bl. N.man/auto off/closed
WRBSEA Cb. Er. Bl. Protection on/open
WRBSAZ Cb. Er. Bl. Protection off/closed
WEFSPERR Status discrepancy monitoring locked
WEFNSEA No status discrepancy monitoring on/open
WEFNSAZ No status discrepancy monitoring off/closed
NLZ Overshoot time travel limit
RMS Feed back contact limit SAG
VBAF Cmd. Output in case of failure
MAUS Man/Auto changeover
TOUS TAG-OUT changeover
REJ/MAN Reject to manual
OP_MODE Operation mode
BSGF Behavior on switch gear fault
External
operating
station

Selection of actuator type (FUNCTION)

Name: FUNCTION
Function: Defines the actuator type. This information is used for the labeling of
the OM650 detail window and the command buttons.
Range of values:
Basic setting:
12
Copying of this document, and giving it to others and use or communication of the contents, are forbidden without express authority. Offenders are liable to the payment of
damages. All rights are reserved in the event of the grant of a patent or the registration of a utility model or design.
Motor / Solenoid
Motor
Solenoid
Switch / Breaker
Motor / Solenoid
Training Center
TXP CLC Course