Siemens TXP-CLC Manual page 184

When creating logic in the AS system it is necessary to connect signals between
diagrams. This is accomplished as follows:
a) Create a SIGDEF (signal definition) for the origin of the signal (see
exercise 3)
b) Send the signal to the target diagram
c) Close the signal on the target diagram
1 . Click on the signal
to connect.
(handle points
appear)
2. Holding the middle mouse button,
select "create connection" from the
window
3. Drag the mouse to the output side of the
page then press the middle mouse button;
select "positive signal" from the window
positive signal
negative signal
action line
flow line
4. In the "dest. ID-code" field type the target diagram
KKS (destination of this signal) then click on "ok"
5. In the next mask the target diagram information is
shown. Nothing needs to be entered in this mask.
Once the signal is closed on the target diagram, all
information will be automatically filled in.
6. Next, we save and close the source diagram and open the
destination diagram.
2
2
Properties
Properties Properties
Parameter
Parameter Parameter
Align
Align Align
Cut
Cut Cut
Deselect
Deselect Deselect
Create connection
Create connection Create connection
Modify connection
Modify connection Modify connection
Disconnect
Disconnect Disconnect
Follow signal
Follow signal Follow signal
Simulation
Simulation Simulation
4
Diagram KKS
Training Center
TXP-CLC Course
1
3
5
Diagram KKS
Target diagram KKS