GE AF-650 GP Programming Manual page 62

Parameter Descriptions
P-30 Stator Resistance (Rs)
Range: Function:
NOTICE
The parameter value is updated after
each torque calibration if option [3]
1st start with store or option [4] Every
start with store is selected in
parameter P-47 Torque Calibration.
P-31 Rotor Resistance (Rr)
Range: Function:
NOTICE
1.0000 [0.0100 -
Ohm 100.0000
*
Parameter P-31 Rotor Resistance (Rr)
Ohm]
does not have effect when
parameter P-20 Motor Construction is
set to [1] PM, non-salient SPM.
Set the rotor resistance value R
shaft performance using 1 of these
methods.
•
Run an Auto Tune on a cold
motor. The frequency converter
measures the value from the
motor. All compensations are reset
to 100%.
•
Enter the R
Obtain the value from the motor
supplier.
•
Use the R
frequency converter establishes
the setting based on the motor
nameplate data.
P-33 Stator Leakage Reactance (X1)
Range: Function:
4.0000 [0.0400 - Set the stator leakage reactance of the
Ohm 400.0000 motor using 1 of these methods:
*
•
Ohm]
•
•
See Illustration 3.20.
DET-618D
AF-650 GP™ Programming Guide
to improve
r
value manually.
r
default setting. The
r
Run an Auto Tune on a cold
motor. The frequency converter
measures the value from the
motor.
Enter the X value manually.
1
Obtain the value from the motor
supplier.
Use the X default setting. The
1
frequency converter establishes
the setting based on the motor
nameplate data.
02/2016 All rights reserved.
P-33 Stator Leakage Reactance (X1)
Range: Function:
NOTICE
The parameter value is updated
after each torque calibration if
option [3] 1st start with store or
option [4] Every start with store is
selected in parameter P-47 Torque
Calibration.
NOTICE
This parameter is only relevant for
ASM.
P-34 Rotor Leakage Reactance (X2)
Range: Function:
4.0000 [0.0400 - Set the rotor leakage reactance of the
Ohm 400.0000 motor using 1 of these methods:
*
•
Ohm]
•
•
See Illustration 3.20.
NOTICE
The parameter value is updated
after each torque calibration if
option [3] 1st start with store or
option [4] Every start with store is
selected in parameter P-47 Torque
Calibration.
NOTICE
This parameter is only relevant for
ASM.
P-35 Main Reactance (Xh)
Range: Function:
100.0000 [1.0000 - Set the main reactance of the motor
Ohm 10000.0000 using 1 of these methods:
*
Ohm] 1.
Run an Auto Tune on a cold
motor. The frequency converter
measures the value from the
motor.
Enter the X value manually.
2
Obtain the value from the motor
supplier.
Use the X default setting. The
2
frequency converter establishes
the setting based on the motor
nameplate data.
Run an Auto Tune on a cold
motor. The frequency
61
3 3