GE AF-650 GP Programming Manual page 31

Parameter Descriptions
3 3
Illustration 3.4
The relation will depend on the type of unit selected in
parameter K-30 Unit for Custom Readout:
Unit Type
Dimensionless
Speed
Flow, volume
Flow, mass
Velocity
Length
Temperature
Pressure
Power
Table 3.4
K-30 Unit for Custom Readout
Option:
[0] None
*
[1] %
[5] PPM
[10] 1/min
[11] rpm
[12] Pulse/s
[20] l/s
[21] l/min
[22] l/h
[23] m3/s
[24] m3/min
[25] m3/h
[30] kg/s
[31] kg/min
30
Speed Relation
Linear
Quadratic
Cubic
Function:
It is possible to program a value to be shown in
the display of the keypad. The value has a linear,
squared, or cubed relation to speed. This relation
depends on the unit selected (see Table 3.4). The
actual calculated value can be read in
parameter DR-09 Custom Readout, and/or shown
in the display by selecting [DR-09] Custom
Readout in parameter K-20 Display Line 1.1 Small to
parameter K-24 Display Line 3 Large.
K-30 Unit for Custom Readout
Option:
[32] kg/h
[33] t/min
[34] t/h
[40] m/s
[41] m/min
[45] m
[60] °C
[70] mbar
[71] bar
[72] Pa
[73] kPa
[74] m WG
[80] kW
[120] GPM
[121] gal/s
[122] gal/min
[123] gal/h
[124] CFM
[125] ft3/s
[126] ft3/min
[127] ft3/h
[130] lb/s
[131] lb/min
[132] lb/h
[140] ft/s
[141] ft/min
[145] ft
[160] °F
[170] psi
[171] lb/in2
[172] in WG
[173] ft WG
[176] kpsi
[177] MPa
[178] kBar
[180] HP
K-31 Min Value of Custom Readout
Range:
0 CustomRea-
doutUnit
*
02/2016 All rights reserved.
Function:
Function:
[-999999.99 - This parameter sets the min.
par. K-32 value of the custom-defined
CustomRea- readout (occurs at zero speed).
doutUnit] Only possible to set different
from 0 when selecting a linear
unit in parameter K-30 Unit for
Custom Readout. For quadratic
and cubic units, the minimum
value is 0.
DET-618D