GE AF-650 GP Programming Manual page 52

Parameter Descriptions
Illustration 3.16 On Delay, Relay
E-27 Off Delay, Relay
Array[20]
Range: Function:
0.01 s [0.01 - Enter the delay of the relay cut out time.
*
600 s] Select 1 of 2 internal mechanical relays in an
array function. See parameter E-24 Function
Relay for details. If the selected event
condition changes before a delay timer
expires, the relay output is unaffected.
Illustration 3.17 Off Delay, Relay
If the selected event condition changes before the on
delay or off delay timer expires, the relay output is
unaffected.
E-51 Terminal 27 Mode
Option: Function:
NOTICE
This parameter cannot be adjusted while
the motor is running.
[0] Input Defines terminal 27 as a digital input.
*
DET-618D
AF-650 GP™ Programming Guide
E-51 Terminal 27 Mode
Option:
[1] Output Defines terminal 27 as a digital output.
E-52 Terminal 29 Mode
Option:
[0] Input
*
[1] Output Defines terminal 29 as a digital output.
E-53 Terminal X30/2 Digital Input
Option: Function:
E-54 Terminal X30/3 Digital Input
Option: Function:
E-55 Terminal X30/4 Digital Input
Option: Function:
E-56 Term X30/6 Digi Out (OPCGPIO)
This parameter is active when OPCGPIO General Purpose I/O
Option Module is mounted in the frequency converter. Functions
are described under E-2# Digital Outputs.
E-57 Term X30/7 Digi Out (OPCGPIO)
This parameter is active when OPCGPIO General Purpose I/O
Option Module is mounted in the frequency converter. Functions
are described under E-2# Digital Outputs.
3.4.4 E-6# Pulse Input
Parameters to configure terminal 29 and 33 as Pulse Train
inputs.
E-60 Term. 29 Low Frequency
Range:
100
Hz
*
02/2016 All rights reserved.
Function:
Function:
NOTICE
This parameter is available for AF-650 GP
only.
Defines terminal 29 as a digital input.
The options are the same as listed for parameter group
E-0#.
The options are the same as listed for parameter group
E-0#.
The options are the same as listed for parameter group
E-0#.
Function:
[0 - 110000 Enter the low frequency limit
Hz] corresponding to the low motor shaft
speed (that is low reference value) in
parameter E-62 Term. 29 Low Ref./Feedb.
Value. Refer to .
3 3
51