JUKI DX-4000QVP Instruction Manual page 70

69
■ Sewing end
Stop the sewing machine.
★
Thread trimming
<Using the thread trimming button>
Press the thread trimming button to trim the thread.
Lift the presser foot and remove the material from the
sewing machine.
Notes for thread trimming:
1. Do not use thread thicker than No.30.
2. After trimming, the stitch can be done without pulling up
bobbin thread.
3. When sewing again after thread trimming, if you pull
up the bobbin thread again and place it underneath the
presser foot together with needle thread, you can avoid
birds nest on the wrong side of the fabric.
4. Regularly clean the machine (refer to page 123), as dust
in the area of the thread trimming unit may cause mal-
function.
<Using the foot switch>
Setting > Foot switch functions
Foot switch functions
It is possible to set so as to trim the thread by pressing
the foot switch. (Refer to page 113)
Press the foot switch to trim the thread.
<Using the thread cutter>
Lift the needle and lift the presser foot. In this state, it
is possible to trim the thread with thread trimmer that is
mounted on the face plate cover.
Sewing >
Presser foot lift after trimming setting
It is possible to set so that the presser foot goes up
automatically after thread trimming.
(Refer to page 44)