JUKI DX-4000QVP Instruction Manual page 36

3
35
Lightly holding
the bobbin with
your right hand
C
5
3
Thread .
* When pulling bobbin thread, bobbin rotates
counterclockwise. If bobbin rotates clockwise,
put the bobbin upside down.
6
Pull the thread along the guide until built-
in cutter C is reached. Finally, trim the
thread with built-in cutter C.
7
Close the hook cover.
You can start to sew in this condition (without
pulling up the bobbin thread), however, if you
want to sew with the bobbin thread pulled out,
refer to "Pulling up the bobbin thread" in the
page 40.