JUKI DX-4000QVP Instruction Manual page 23

■ Turning the power ON
* This screen is not displayed when you turn ON the power to the sew-
ing machine next time.
● Lock mode
The power to the sewing machine should be turned OFF for the sake of safety when changing the presser foot,
changing the throat plate and feed dog, changing the needle or taking care of the sewing machine. However,
those kinds of work can be carried out while retaining the current settings of the sewing machine by putting the
sewing machine in the lock mode.
・ When you want to put the sewing machine in the lock mode, keep the feed dog UP / DOWN / LOCK MODE
button held pressed for two seconds.
・ When you want to reset the lock mode, keep the feed dog UP / DOWN / LOCK MODE button held pressed
for two seconds.
・ When turning off the machine, lock mode is disengaged.
Turn ON the power switch. (Turn to "I")
* Be aware that the presser foot goes up automatically
when the power to the sewing machine is turned ON.
The screen shown on the left when the power to the sewing
machine is turned ON.
The needle moves and the screen shown on the left disap-
pears by pressing [OK] .
Do not place fingers under
the needle
If the sewing machine is put in the lock mode, operation of all
operating buttons, operating keys and operation panel will be
disabled. In addition, the sewing machine itself will also be
disabled.
Even in this state, the presser foot lifting lever and the knee
lifting lever can be operated.
The screen shown on the left is dis-
played when you turn ON the power
to the sewing machine for the first
time after the delivery.
1. Select the language for display.
2. Press [Start].
3. Set the wireless LAN to which the
sewing machine is connected.
4. Enter the password for the wire-
less LAN.
5. Press [CONNECT] .
22