JUKI DX-4000QVP Instruction Manual page 34

❸
33
❹
❺
❻
4
Set the bobbin on the bobbin winding
shaft ❸ .
5
Wind the thread on the upper part of
the bobbin by four to five turns in the
clockwise direction while taking care
not to allow the thread coming from the
bobbin winding thread guide to loosen.
Put the thread end into the guide ❹ at
the bobbin winding shaft and pull it to the
right side to cut it.
6
Turn the power ON.
7
Push the bobbin winding regulator ❺
towards the bobbin to start winding the
bobbin.
* Be careful that the bobbin winding regulator
works as a switch.
8
When winding is finished, the shaft
stops automatically, the bobbin winding
regulator moves to right and return to the
original position.
Remove the bobbin from the bobbin
winding shaft and cut the thread by cutter
❻ .
* Bobbin winding will automatically stop even
while winding, when the winding speed is
reduced due to a load to the bobbin winding
motor caused by thread tangling.
* The bobbin winder automatically stops for the
sake of safety after it has turned continuously
at a certain period of time.