JUKI DX-4000QVP Instruction Manual page 69

■ When changing the sewing direction
① Stop the sewing machine when the position for chang-
ing the direction of sewing is reached.
② If the needle is not penetrated into the material at that
position, press the needle up/down button to allow
the needle to penetrate into the material. Then, lift the
presser foot.
* The sewing machine has been factory-set at the
time of shipment, so that the needle penetrates into
the material when the sewing machine is stopped.
③ Change the direction of sewing with the needle pen-
etrated into the material. Then, lower the presser foot
and start sewing.
Setting > Stop position of needle
Changing over the needle stop position
It is possible to change the stop position to which is the
needle is brought when the sewing machine is stopped.
(Refer to page 110)
Setting > Pivot
Presser foot pivot function
You can select the setting where the presser foot goes
up with the needle held in the needle-down stop position
when you stop the sewing machine.
(Refer to page 110)
68