JUKI DX-4000QVP Instruction Manual page 40

■ Automatic needle threader
8
* Be careful that the
cutter is inside.
7
39
9
Turn off the machine or leave the
Machine in Lock Mode
* When twin needle is used, the automatic needle
threader can not be used.
* Use the needle: No.11-16 and the thread: No.30-90.
1
Lower the presser foot with the presser
foot lifting lever.
* The automatic needle threader sometimes fails
to thread the needle when the presser foot is
raised.
2
7
Thread to and cut the thread with the
8
thread cutter
3
Lower the threading lever
to a complete stop.
* Lower the threading lever slowly.
4
Pull the thread loop away from you and
draw the thread end through the needle
eyelet.
5
Lift the presser foot. Then, draw the
needle thread backward.
Pull out the thread from the needle eye by
approx.10 cm or 4 inches long.
It is possible to start sewing without
pulling up the bobbin thread.
.
9
until it comes