JUKI DX-4000QVP Instruction Manual page 118

● Updating the software
Contact your distributor if you have any question
about the software.
< In the case of using a USB thumb drive >
Precaution to be observed in saving data on the USB thumb drive
* Save the software you have downloaded in the storage space directly under the USB thumb drive as it is.
One folder that is named [prog] and one zip file that is named [HZLUX8_PANEL_********.zip] are saved.
* If any previous version of software remains on the USB thumb drive, it must be deleted before saving the
newly downloaded software.
* The USB thumb drive must have a storage capacity of 1 GB or more.
❶
117
❷
Do not turn the power OFF while updat-
ing of the software is in progress.
Insert USB thumb drive ❷ into USB slot ❶ .
Select [USB].
Press [Start the updating].
When you press [Start the updating] on the next screen,
updating of the software starts.
Do not turn the power OFF while updat-
ing of the software is in progress.
When the software has been normally updated, the
message [Software updating is completed] is displayed.
Remove the USB thumb drive and turn OFF the power
to the sewing machine. Then, re-turn the power ON.