Changing Parameter Settings Using Ams Device Manager; Configure/Setup (Level Transducer Block-Ltb); Identification (Ltb) - Siemens SITRANS LR250 Operating Instructions Manual

Changing parameter settings using AMS Device
Manager
Notes:
• For a complete list of parameters, see
• For more detailed explanations of the parameters listed below see the pages
referenced.
1) Adjust parameter values in the parameter value field in Configure/Setup view, then
click on Apply to write the new values to the device. The parameter field will display
in yellow until the value has been written to the device.
2) Click on OK only if you wish to update all parameters and exit device view.

Configure/Setup (Level Transducer Block-LTB)

Identification (LTB)

Navigate to Configure/Setup > LTB > Identification.
Identification:
• TAG
Read only. Description for the associated block: device tag prefixed by
block type.
• Descriptor (see
• Transducer Block Type
Read only. Identifies the type of transducer block.
• Strategy
Used to identify grouping of blocks.
• Plant Unit
The identification number of the plant unit. For example, can be used in the
host for sorting alarms.
7ML19985KL01
Descriptor on page 97
SITRANS LR250 (FF) – OPERATING INSTRUCTIONS
Parameter Reference (LUI) on page 96
)
.
Page 49