AT&T MERLIN MAIL System Programming And Maintenance Manual page 89

MERLIN MAIL—ML System Programming
6. Enter [1] [5] followed by [#] as the Class of Service assigned to this
mailbox.
If the MERLIN MAIL—ML system is set for monolingual operation, the
system prompts you to enter the mailbox name. Skip to Step 9.
If the MERLIN MAIL—ML system is set for bilingual operation, the system
prompts you to select the mailbox language. Go to Step 7.
7. Enter [1] to select the primary system language as the Delayed
Call Handling mailbox language.
The system plays the language selected, followed by a prompt to approve
the selection.
8. Choose one:
— [*] [#] to approve the language selected. Go to Step 9.
— [1] to re-enter the language selected. Go back to Step 7.
9. Use dialpad to enter the mailbox name. To name this mailbox DLAY,
enter [3][1] [5][3] [2][1] [9][3] [#] To enter a different mailbox name,
substitute number codes for letters, as shown in the Letter Key shown
in the previous procedure. Use the dialpad to enter the mailbox name
(up to four letters) followed by [#]
The system echoes the mailbox name letters, followed by a prompt to
confirm them.
10. Select one:
— [9] for "Yes" to confirm the name.
subscriber's name at the tone.
— [6] for "No' to cancel the mailbox name. Go back to Step 9.
11. Record the mailbox name, then press [1]
The system plays back the subscriber's name, then prompts you to
confirm it.
The mailbox name is saved and the system prompts you to record the
Programming Voice Mailboxes
3-27