Connecting The Remote Maintenance Device To The Unit - AT&T MERLIN MAIL System Programming And Maintenance Manual

Installation
Connecting the Remote Maintenance
Device to-the Unit
Refer to Figures 2-6, 2-7, and 2-8 as you follow the instructions below to
connect the Remote Maintenance Device:
NOTE:
Skip step 1 for RMD Mk Ill.
1. The Remote Maintenance Device comes preset from the factory.
Confirm that the switches, located on the bottom of the modem, are set
as follows:
NOTE:
If you reset the switches, you must switch the Remote
Maintenance Device off and back on again before the new
settings take effect.
2. Use the modem cable provided to connect the RS-232-C port on the
Remote Maintenance Device to the COM1 port on the MERLIN
MAIL—ML unit. For the location of the RS-232-C port, refer to Figure
2-7 (RMD) or Figure 2-8 (RMD Mk Ill). For the location of the COM1
port on the MERLIN MAIL—ML unit, see Figure 2-6.
Installing the MERLIN MAIL—ML Unit
2-13