Usb Application Without Usb Suspend Function; Airplane Mode - Quectel EC25-AUX Hardware Design

 Sending data to EC25 via USB will wake up the module.
 When EC25 has a URC to report, RI signal will wake up the host.

3.5.1.4. USB Application without USB Suspend Function

If the host does not support USB suspend function, USB_VBUS should be disconnected via an additional
control circuit to let the module enter sleep mode.
 Execute AT+QSCLK=1 command to enable sleep mode.
 Ensure the DTR is held at high level or keep it open.
 Disconnect USB_VBUS.
The following figure shows the connection between the module and the host.
Figure 6: Sleep Mode Application without Suspend Function
Switching on the power switch to supply power to USB_VBUS will wake up the module.
NOTE
Please pay attention to the level match shown in dotted line between the module and the host. For more
details about EC25 power management application, please refer to document [1].

3.5.2. Airplane Mode

When the module enters airplane mode, the RF function does not work, and all AT commands correlative
with RF function will be inaccessible. This mode can be set via the following ways.
EC25_Hardware_Design
LTE Standard Module Series
EC25 Hardware Design
39 / 130