Function Modules And Communication Processors Used On The S7-400H; Fms And Cps Used Centrally - Siemens SIMATIC S7-400H Manual

Function Modules and Communication
Processors Used on the S7-400H
You can use the following function modules (FMs) and communication processors
(CPs) on a S7-400:

FMs and CPs used centrally

Module
Counter module FM 450
Communication processor
CP441-1 (point-to-point CP441-1 (point-to-point
connection)
Communication processor
CP441-2 (point-to-point CP441-2 (point-to-point
connection)
Communications processor
CP443-1 Multi (SINEC H1
(Ethernet), TCP/ISO transport) (Ethernet), TCP/ISO transport)
Communications processor
CP443-5 Basic (PROFIBUS;
S7 communications)
Communication processor
CP443-5 Extended
(PROFIBUS; master on
1)
PROFIBUS-DP)
Communication processor
CP443-5 Extended
1) 2)
(PROFIBUS DPV1)
1)
Only these modules should be used as external master interfaces on the PROFIBUS DP.
2)
Only this module supports DPV1 as external DP master interface (in accordance with IEC 61158/
EN 50170).
Automation System S7-400H Fault-tolerant Systems
A5E00068197-07
Order no.
6ES7450-1AP00-0AE0
6ES7441-1AA02-0AE0
6ES7441-1AA03-0XE0
6ES7441-2AA02-0AE0
6ES7441-2AA03-0XE0
6GK7443-1EX10-0XE0 Version 1 or later
6GK7443-1EX11-0XE0
6GK7443-5FX01-0XE0 Version 1 or later
6GK7443-5DX02-0XE0 Version 2 or later
6GK7443-5DX03-0XE0 Version 2 or later
Release one-way
Vesion 2 or later Yes
Vesion 2 or later Yes
Version 1 or later
with firmware V1.0.0
Vesion 2 or later Yes
Version 1 or later
with firmware V1.0.0
Yes
with firmware V1.0.1
Version 1 or later Yes
with firmware V1.1.0
Yes
with firmware V3.1
Yes
with firmware V3.2.3
Yes
with firmware V4.0.0
E
redundant
No
No
No
Yes
Yes
Yes
Yes
Yes
E-1