12.5
Header Bar
The Header Bar on the graphic display panel displays three system parameters: the System Load, Current Status, and
System Time.
No.
System Load – Load per each phase as percent of full load. Low – Less than 10% Load.
1
2
Current Status – UPS status at the moment. (Status is delayed by a few seconds)
3
System Time – Current time in AM-PM format
12.6
Footer Bar
The Footer Bar on the graphic display panel displays three system parameters:
No.
1
Fault – Displays last fault sensed by UPS. A Fault causes the UPS to switch to bypass
2
Warning – Displays last warning sensed by UPS. Multiple frequent warnings of the same
3
UPS Mode – Current state of UPS.
4400 Series Installation and Operation Manual – 64527-008
1
Header Bar Components
FIGURE 12.4: HEADER BAR DISPLAY COMPONENTS
UPSOL
1
Footer Bar Components
and it will not automatically reset.
type may induce a fault condition.
FIGURE 12.5: FOOTER BAR DISPLAY COMPONENTS
3
2
Function
INVOL
BYPASS
3
2
Function
77
Need help?
Do you have a question about the 4400 Series and is the answer not in the manual?
Questions and answers