12.16
Tab: Setup
The SETUP tab allows the user to adjust certain UPS parameters. The setup tab shows 12 buttons. Inactive buttons are
indicated with a "x" in the lower right-hand corner of the button. The table below, right, shows a typical SETUP button.
4400 Series UPS
SETUP
ASYN
Param.
Prefix
0
UPS Identification, Serial number, Start-up Date, software version
1
Input line-line and line-neutral V/I values, V/I percent of rated value, and frequency
2
Output line-line and line-neutral V/I values, V/I percent of rated value, and frequency
3
Bypass line-line and line-neutral V/I values, V/I percent of rated value, and frequency
4
DC Bus Voltage, DC Under Voltage Level, Startup Voltage Level
5
Battery Voltage/Current, shutdown voltage, battery test enable
6
Control and Configuration – UPS time/date/status, faults, warnings, password management
7
UPS Operation time, Number of Faults, Backup, Operations.
8
Display and Ext Comm. – Disp. S/W version, buzzer status, display calibration values.
RemotEye I/P address, data and network status.
4400 Series Installation and Operation Manual – 64527-008
Parameter Category
FIGURE 12.14: PARAMETER CATEGORIES
Typical
Significance
Button
No "x" in the lower right corner
indicates the button is active.
Pressing the button will open
a data page displaying the
parameters available at the
current security level.
A button that has an "x" in the
lower right corner is inactive
and cannot be accessed at the
current security level.
ASYN
87