4400 Series Installation and Operation Manual – 64527-008
DO NOT tilt the UPS more than 10° from upright position.
Tilting the UPS more than 10° may cause crushing, trapping or other
DO NOT transport, move, store, or place the UPS on its side.
Excessive force applied from heavy components inside may damage
Avoid vibration or shock exceeding 0.5 g.
Failing to observe this precaution may cause damage to the UPS.
DO NOT allow the UPS to suffer shock or impact when unpacking.
Tools used to remove packaging materials may cause damage to the
DO NOT install the UPS where water may fall on or enter it.
Water may cause electrical shock, personal injury or UPS failure.
DO NOT push or pull on the sides of the packaging or the
UPS to move it. Always use a crane, forklift, or pallet jack for
transporting and positioning the UPS.
Pushing/pulling on the sides of the unit to move it may result in damage
to the UPS.