Plastic And Vinyl; Windows; Stainless Steel; High Pressure Laminate - PREVOST H3-45 VIP Owner's Manual

8-4 Care and Maintenance
Oil, Grease And Paint
Remove excess using a knife. Treat with method
one followed by method two. If stain persists, repeat
procedure.
Rust Stains
Remove rust stains by following method two. Apply
a warm oxalic acid solution to stained area. Rinse
with water.
Tar
Soften tar with mineral spirits, then treat using
method one followed by method two.
Chewing Gum
Soften gum with cyclohexane. Carefully scrape off
stains using a sharp knife or razor blade.

PLASTIC AND VINYL

Clean plastic and vinyl trim using a clean damp cloth
or sponge. For vinyl trim marks, use a lukewarm all-
purpose cleaner or a mild saddle soap. Remove
water spots and soap traces using a clean damp
cloth or sponge. Dry with a clean soft cloth.
Remove grease, tar or oil stains with a clean cloth or
sponge and an all- purpose or solvent- type vinyl
cleaner.
Apply a colorless vinyl or leather protective product
to maintain the luster and pliability of the plastic or
vinyl surface.

WINDOWS

Clean the inside of the windows with a solution of
one part vinegar to ten parts water.

STAINLESS STEEL

Use a stainless steel cleaner and follow the
manufacturer's instructions. Stainless steel cleaning
solution may be ordered from Prevost quoting part
number 680356.

HIGH PRESSURE LAMINATE

Remove stains on laminated surfaces with a
household detergent, methylated spirits or mineral
spirits. Clean with a mild liquid abrasive and water
solution if stain persists.

RUBBER COMPONENTS

Use only pure water or glycerin to clean stains on

rubber components.

Never use solvents on rubber components.

FLOOR CLEANING

To keep its original appearance, wash the floor
regularly. Clean vinyl floors with a quality nonionic
detergent cleaner or a household all-purpose cleaner.
Follow the manufacturer's recommendations for
cleaning.
Remove any excess detergent solution using a
wet/dry vacuum or mop. Rinse floor with a solution
of one part Clorox to ten parts warm water.
Polish dry floor using a high- speed buffer and a
smooth red 3-M polishing pad.
Mop floor periodically with a solution of 5 percent
Clorox in warm water.
NOTE
For custom or special floor covering materials,
consult the manufacturer or your converter for
information on how to clean and maintain these
types of floors.
Using a water hose to clean the floor is prohibited
since it could cause electrical shorts or damage
the electrical system.

EXTERIOR SURFACES

Frequent washing and waxing of the vehicle exterior
will help protect the finish and luster. The paint finish
is attacked by the abrasive effects of airborne
particles and corrosive pollutants.
Before washing the exterior of the vehicle, close the
fresh air dampers using the "REC" button located on
HVAC control panel and on the air intake duct in the
evaporator compartment. Install keyhole protectors
to prevent water from penetrating. Rinse vehicle
with water to remove all loose dirt. Wash vehicle
using quality brand car wash soap. Follow
PA-1638 Owner's Manual X3-45 VIP
CAUTION
CAUTION