Tank Drain Assembly - Toro Multi Pro 1750 Service Manual

Tank Drain Assembly

Disassembly (Fig. 30)
IMPORTANT: Make sure to remove and neutralize
chemicals from tank and spray components before
disassembly. Wear protective clothing, chemical re-
sistant gloves and eye protection during repair.
1. Park machine on a level surface, stop spray pump,
stop engine and engage parking brake. Remove key
from ignition switch.
2. Drain spray tank.
3. Remove fork (item 8) and remove drain hose assem-
bly from tank.
4. Disassemble drain hose assembly as needed. Dis-
card all removed O−rings and gaskets.
NOTE: The drain valve is a non adjustable, non re-
pairable component. Replace the valve if necessary.
Assembly (Fig. 30)
NOTE: Replace all removed O−rings and gaskets.
Coat all O−rings with vegetable oil before installation to
reduce the chance of damage during assembly.
1. Assemble drain hose assembly. Apply thread
sealant to hose connector threads (item 13).
2. Install drain hose to tank.
3. Make sure that drain valve is closed and secured to
sprayer.
4. Check spray tank for leaks. Repair all leaks before
returning the sprayer to service.
Spray System
1
2
3
4
6
7
9
10
11
RIGHT
FRONT
1. Adapter (in tank)
2. Gasket
3. Bulkhead nut
4. O−Ring
5. Fork
6. Adapter
7. O−Ring
8. Fork
Page 6 − 44
5
8
Thread
Sealant
12
10
13
14
15
16
Figure 30
9. Elbow fitting
10. Hose clamp (2)
11. Hose (drain)
12. Cable tie
13. Hose connector
14. Drain valve
15. Flange head screw (2)
16. Hex Nut (2)
Multi Pro 1750