Infocenter Display; Infocenter Display Screens - Toro Multi Pro 1750 Service Manual

InfoCenter Display

The InfoCenter Display used on your Multi Pro is a LCD
device that is located on the console arm (Fig. 8). The
InfoCenter provides information for machine Operators,
it provides electrical system diagnostic assistance for
2
technicians, and provides access to adjustable machine
settings (Fig. 9).
1
Power for the InfoCenter is available when energized by
the main power relay (ignition switch in the RUN or
START position). The InfoCenter Display is protected by
a 15 amp fuse located in the main fuse block. A CAN−
bus system provides communication necessary for ma-
chine operation between the Toro Electronic Controller
(TEC) and the InfoCenter.
Use the InfoCenter Display to test TEC inputs and quali-
fiers when troubleshooting an electrical problem on your
Multi Pro 1750 (see Using the InfoCenter Display to Test
TEC Inputs and Outputs in this chapter).
Your machine is equipped with an Toro Electronic Con-
troller (TEC) which monitors interlock switch (input) op-
Figure 8
eration. If one or more inputs are not in the correct
1. Control console 2. InfoCenter Display
position to allow certain machine operations, or are mal-
functioning, the fault indicator will illuminate and an advi-
sory screen will appear on the InfoCenter Display (see
Operator Advisory Screen and Operator Advisories in
this chapter).
NOTE: Icons used by the InfoCenter display are identi-
fied in the machine Operator's Manual.
Multi Pro 1750 Electrical System
Page 5 − 7