34.Apply multi−purpose grease on lip of oil seal and in-
stall new speed sensor oil seal in upper cover.
35.Apply silicone sealant to mating surface of upper
cover. Pay attention to direction of cover and install.
Tighten cap screws from 18 to 22 ft−lb (25 to 29 N−m).
36.If removed, slide speed sensor into upper cover and
secure with cap screw and lock washer.
37.Apply multi−purpose grease on lip of oil seal and in-
stall new input shaft oil seal in center plate.
38.Position input shaft cover plate to center plate and
secure with cap screws. Tighten cap screws from 18 to
22 ft−lb (25 to 29 N−m).
Multi Pro 1750
1. Flange head screw
2. Speed sensor
3. Flange head screw (4)
18 to 22 ft−lb
(25 to 29 N−m)
3
1
2
1. Input shaft seal
2. Input shaft cover
Page 7 − 51
1
18 to 22 ft−lb
2
(25 to 29 N−m)
5
3
4
Figure 99
4. Upper cover
5. Oil seal
Figure 100
3. Cap screw (3)
Drive Train