Toro Multi Pro 1750 Service Manual page 246

16.Remove all caps or plugs placed on hydraulic hoses
and fittings during disassembly.
17.Lubricate new suction and return hose O−rings with
Dexron III ATF oil. Install suction and return hoses to
transaxle.
18.Install differential lock cable. Check and adjust differ-
ential lock cable (see Shift Cable Adjustment in this
chapter).
19.Position shift cables to cable mount noting cable
identification made during disassembly. Check and ad-
just shift cables (see Shift Cable Adjustment in this
chapter).
20.Install the speed sensor if previously removed. Plug
speed sensor connector into wire harness.
21.Install the neutral switch if previously removed (see
Neutral Switch in Chapter 5 − Electrical System in this
manual). Plug neutral switch connector into wire har-
ness.
22.Lower machine to ground.
WARNING
Connecting battery cables to the wrong post
could result in personal injury and/or damage to
the electrical system.
23.Connect positive (+) cable to battery first and then
negative (−) cable.
24.Fill transaxle with Dexron III ATF oil (see Operator's
Manual).
25.Check transaxle operation and inspect machine for
hydraulic system leaks before returning the machine in-
to service.
Drive Train Page 7 − 20 Multi Pro 1750