Toro Multi Pro 1750 Service Manual page 270

19.Install reverse shaft into transaxle case. Rotate main
shaft and reverse shaft gears to mesh gears when in-
stalling.
20.Install center plate:
A. Insert dowel pins into transaxle case.
B. Apply silicone sealant onto mating surface of
center plate.
C. Position center plate to transaxle.
D. Install and tighten fifteen (15) flange head screws
to a torque from 18 to 22 ft−lb (25 to 29 N−m).
E. Apply multi−purpose grease onto lips of oil seal,
then insert oil seal flush with face of housing.
NOTE: The thickest shim of the shim set should be
positioned against the retaining ring.
21.Insert tabbed shim against the bearing. Insert shim
set against the tabbed shim. Use thickest shims in set
possible, that will permit installation of the retaining ring.
Drive Train
1. Reverse shaft
18 to 22 ft−lb
(25 to 29 N−m)
4
1
1. Seal cap
2. Shims
Page 7 − 44
1
Figure 79
2. Bearing (gear case)
Figure 80
Figure 81
3. Shim
4. Snap ring
2
3
2
Multi Pro 1750