Special Tools - Toro Multi Pro 1750 Service Manual

Special Tools

Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The multimeter can test electrical components and cir-
cuits for current, resistance or voltage. Obtain this tool
locally.
NOTE: Toro recommends the use of a DIGITAL Volt−
Ohm−Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Dielectric Gel
Dielectric gel should be used to prevent corrosion of
connection terminals. To ensure complete coating of ter-
minals, liberally apply gel to both component and wire
harness connector, plug connector to component, un-
plug connector, reapply gel to both surfaces and then
connect harness connector to component. Connectors
should be thoroughly packed with gel for effective re-
sults.
Do not use dielectric gel on sealed connection terminals
as the gel can unseat connector seals during assembly.
Toro Part Number: 107−0342
Terminal Protector
Aerosol spray that should be used on battery terminals,
ring terminals, and fork terminals to reduce corrosion
problems. Apply battery terminal protector to the con-
nection after the battery cable, ring terminal, or fork ter-
minal has been secured.
Toro Part Number: 107−0392
Multi Pro 1750
Page 5 − 3
Figure 1
Figure 2
Figure 3
Electrical System