Toro Multi Pro 1750 Service Manual page 244

17.Remove the four (4) flange head screws and flange
nuts that secure the wheel hub and bearing to the ma-
chine. Use the hole in the wheel hub to access flange
head screws. Remove wheel hub and bearing assembly
from machine.
18.Remove two (2) cap screws and lock nuts from
transaxle end of the left wheel driveshaft assembly.
Slide the left driveshaft off of the transaxle output shaft.
The transaxle assembly weighs approximately
100 lbs (45 kg). Use an appropriate lifting device
to safely lower the transaxle assembly.
19.Support transaxle to prevent it from shifting or falling.
Remove two (2) cap screws that secure top of transaxle
to machine frame (item 11). Remove four (4) flange
head screws that secure front of transaxle to machine
frame.
Drive Train
CAUTION
20.Support the right wheel driveshaft assembly and
move the transaxle assembly to the left until the right
wheel driveshaft separates. Lower transaxle assembly
from the machine.
21.Remove right wheel driveshaft yoke from transaxle
if necessary.
22.If necessary, remove shift cable mount and differen-
tial lock cable mount from transaxle.
23.Remove oil strainer from transaxle. Locate, remove
and discard strainer O−ring.
Page 7 − 18 Multi Pro 1750