Toro Multi Pro 1750 Service Manual page 236

Differential Lock Cable Removal (Fig. 4)
1. Park vehicle on a level surface, shut engine off and
engage the parking brake. Remove key from the ignition
switch.
2. Remove knob from differential lock lever and remove
rear switch panel (item 4). Disconnect rear switch panel
switches from wire harness and remove choke cable
from rear switch panel for better access to cable.
3. Remove hair pin and clevis pin that secure the differ-
ential lock cable clevis to differential lock lever.
4. Remove the bottom console cover (item 1) and right
front fender assembly.
5. Remove retaining ring (item 18) from differential lock
cable and remove cable from slot in frame plate.
6. Remove differential cable from transaxle. (Fig. 6):
A. Loosen jam nuts on bulkhead fitting of cable.
B. Disconnect cable from bracket on transaxle.
C. Remove spring from differential lock lever on
transaxle.
7. Record routing of differential lock cable and location
of cable ties used to secure cable to machine. Remove
cable from machine.
Differential Lock Cable Installation (Fig. 4)
1. Route shift cable in same location as recorded dur-
ing cable removal.
Drive Train
1. Differential lock cable
2. Install differential cable to transaxle. (Fig. 6):
A. Hook spring to differential lock lever on transaxle.
B. Install cable to bracket on transaxle.
C. Tighten jam nuts on bulkhead fitting of cable fin-
ger tight.
3. Fit cable to slot in frame plate and install retaining
ring (item 18).
4. Install the right front fender assembly and bottom
console cover (item 1).
5. Install hair pin and clevis pin that secure the differen-
tial lock cable clevis to differential lock lever.
6. Install rear switch panel and lever knob.
7. Check and adjust differential lock cable (see Shift
Cable Adjustment in this chapter).
Page 7 − 10
1
Figure 6
2. Bulkhead jam nuts
Multi Pro 1750
2