Settings Screen - Toro Multi Pro 1750 Service Manual

Settings Screen

The settings screen (Fig 16) allows the operator or tech-
nician to modify a variety of machine functions, custom-
ize the InfoCenter display, and provides access to
unlock various protected menus and settings. To scroll
through the list of functions, view its current setting, and
select (highlight) the setting to be modified, press the
center/down button (as indicated by the
of the screen).
To return to the previous screen, press the left/back but-
ton (as indicated by the
Hill Assist: Use the right/forward button (as indicated
by the at the bottom of the screen) to enable
disable the hill assist feature. Once enabled, the hill
assist feature is activated when the clutch pedal and
brake pedal are pressed, the vehicle speed is zero (0)
and the required brake pressure has been reached. The
brake will remain engaged for a second or two after the
operator releases the brake pedal to allow time for en-
gaging the clutch and accelerator.
Spray Tank Alert: Use the right/forward button (as indi-
cated by the at the bottom of the screen) to enter the
desired spray tank alert volume. The indicator light on
the InfoCenter Display will illuminate when the spray
tank reaches the volume entered. The volume setting
for the alert can be adjusted with the center button − or
right button +. The spray tank alert volume resets to 1
gal/ltr any time the spray tank volume is entered.
Units: Use the right/forward button (as indicated by the
at the bottom of the screen) to select between Eng-
lish, Turf or SI (metric) units of measure.
Language: Use the right/forward button (as indicated
by the at the bottom of the screen) to select from nu-
merous language options. Allow the desired selection to
remain in view for five (5) seconds. The fault indicator
will illuminate and an operator advisory #242 (Value
Saved) will appear on the InfoCenter display to confirm
that the change has been recorded.
Backlight: Press the right/forward button (as indicat-
ed by the at the bottom of the screen) then increase
or decrease the InfoCenter Display brightness (as indi-
cated by the − and the + at the bottom of the screen). Al-
low the desired selection to remain in view for five (5)
seconds. The fault indicator will illuminate and an opera-
tor advisory #242 (Value Saved) will appear on the Info-
Center display to confirm that the change has been
recorded.
Electrical System
at the bottom
at the bottom of the screen).
SETTINGS SCREEN
1
2
or
1. Settings items
2. Left/back button
Contrast: Press the right/forward button (as indicat-
ed by the at the bottom of the screen) then increase
or decrease the InfoCenter Display contrast (as indicat-
ed by the − and the + at the bottom of the screen). Allow
the desired selection to remain in view for five (5) sec-
onds. The fault indicator will illuminate and an operator
advisory #242 (Value Saved) will appear on the InfoCen-
ter display to confirm that the change has been record-
ed.
Protected Menus: Authorized individuals can enter the
four (4) digit Personal Identification Number (PIN) to re-
veal the following service functions (see Service
Screens in this chapter):
S Flow Rate
S Flow Calibration Value
S Speed Calibration Value
S Clear System Faults
S Service Timer Reset
Entering the correct PIN will also reveal and allow ad-
justment of various machine functions on the settings
screen if Protect Settings is enabled
Screen − Protect Settings).
Use the center/down button and right/forward button (as
indicated by the
screen) to enter the four (4) digit PIN. Once the correct
PIN has been entered, press the center/down button (as
Page 5 − 14
Settings
Hill Assist:
Alert: OFF
Units: US
3
Figure 16
3. Center/down button
4. Right/forward button
(see Settings
and the at the bottom of the
Multi Pro 1750
4