6 Remote Monitoring
6-8-4
Operation Command
The FINS-mini text of the Operation Command is as follows:
Command text:
MRC
'30'
2
MRC/SRC
Command code
Related information
Command codes:
Command
code
'01'
Automatic
Measurement
Start Command
'06'
Software Reset
Command
'0B'
Parameter
Initialization
Command
Response text:
MRC
'30'
2
MRC/SRC
Response code
6 - 20
SRC
Command code
Related information
'05'
'00'
2
2
2 bytes
The Operation Command. Specify '3005'.
Enter the command code that indicates the type of Operation Command. Refer to the
table below.
Information related to the Operation Command. Enter '00' for the K7GE-MG.
Operation
Related
Command
information
'00'
'00'
'00'
SRC
Response codes MRES/SRES
'05'
2
4 bytes
The content from the command text is entered as-is.
The result of executing the command is entered. Refer to the table below.
Command description
Measurement starts regardless of whether the external contacts
connected to the trigger input terminals are ON or OFF.
The power ON reset process is executed in the same way as
when the Reset Key on the Main Unit front part is pressed. The
K7GE-MG enters the same initial state as after the power is
turned ON.
Returns the setting values of all setting parameters to the
factory default values.
Insulation Resistance Monitoring Device User's Manual (N224)