Omron K7GE-MG User Manual page 54

3 Installation and Wiring
Mounting to DIN Track
•
Mounting method
After connecting the Units, pull
down all DIN Track mounting
hooks on the bottom.
Next, hook the upper hook of
the K7GE-MG onto the DIN
Track and push in the Units.
Finally, raise all the DIN Track
mounting hooks that were
pulled down and fix the K7GE-MG to the DIN Track.
•
Dismounting method
Pull out the DIN Track mounting hooks with a flat-blade screwdriver and
lift the Unit from the bottom to remove it.
Leave at least 30 mm of space between the K7GE-MG and other devices
to allow easy installation and removal.
•
Install an end plate on the left and right sides.
To prevent a faulty contact between the connectors due to vibrations,
mount the Units without any gap so that they are pinched between the
end plates. Up to one Main Unit and eight Probe Units can be installed
between End Plates.
•
Install the K7GE-MG in the horizontal or vertical
direction as much as possible, although there is
no restriction on the mounting direction.
•
Recommended DIN Track
Model
PFP-100N
PFP-50N
•
Recommended end plates
Model
PFP-M
3 - 4
(1)
Specifications
1,000 × 35 × 7.3 mm (L × W × H)
500 × 35 × 7.3 mm (L × W × H)
Specifications
For PFP-100N/PFP-50N
(2)
Downward
Sidewise
Manufacturer
OMRON
OMRON
Manufacturer
OMRON
Insulation Resistance Monitoring Device User's Manual (N224)
(3)
30 mm
above
End plate End plate
Vertical Horizontal
Lengthwise