Omron K7GE-MG User Manual page 139

Response Frame
Normal operation:
STX Node number
H'02
1 2
Specified FINS command could not be executed:
STX Node number
H'02
1 2
Command frame error:
STX Node number
H'02
1 2
No response to command frames that are not completed up to the ETX.BCC character.
STX
Node number
Sub-address
Completion code
FINS-mini command
text
ETX
BCC
Insulation Resistance Monitoring Device User's Manual (N224)
Sub-address Completion code FINS-mini command text
'00'
2 2
Sub-address Completion code FINS-mini command text
'00' '0F'
2 2
Sub-address Completion code ETX
'00' H'03
2 2 1
This code indicates the beginning of the communications frame. This code is always
set as the first byte (H'02).
The number specified in the command frame is entered as-is.
Always set the sub-address to '00'.
The result of executing the command frame is entered. Refer to Completion code on
page 6-16.
This is the command response text area. For details, refer to FINS-mini Text on page
6-16.
This code indicates the end of the text. (H'03)
This is the Block Check Character. A value found by calculating the exclusive OR of
the bytes from the node number up to ETX.
ETX BCC
H'03
1 1 byte
ETX BCC
H'03
1 1
BCC
1 byte
6 Remote Monitoring
6 - 15
6