4.
Press the Shift Key to enter the monitoring state.
•
The setting value is displayed.
5.
Press the Shift Key again to move to the setting change state.
•
The value that can be changed starts flashing.
6.
Use the Up Key to change the setting value.
7.
Press the Mode Key to move to the next setting parameter.
•
The changed setting value is saved in the internal memory.
8.
Press the Level Key for at least 1 second to return to the
Operation Level.
•
The LVL/CH display will indicate 1, and the CH indicator will light
to show that the Operation Level has been entered.
---- indicates measurement standby.
•
Press the Level Key at the Communications Setting Level for
less than 1 second to return to the Initial Setting Level.
Follow the same procedure for other communications setting parameters.
Insulation Resistance Monitoring Device User's Manual (N224)
5 Using Setting Parameters
TRIG
LVL
1
MANU
TRIG
LVL
1
MANU
TRIG
LVL
1
MANU
TRIG
LVL
1
MANU
1 second
TRIG
----
1
CH
MANU
Less than
TRIG
LVL
1 second
mxch
0
MANU
FIN
9.6
ERR
AGE
FIN
9.6
ERR
AGE
FIN
57.6
ERR
AGE
FIN
len
ERR
AGE
FIN
5
ERR
AGE
FIN
ERR
AGE
5 - 27