Omron K7GE-MG User Manual page 99

 Moving to the Protect
Level
At the Operation Level, the
main display part starts to
flash when the Level Key and
Mode Key together (
are pressed for at least 1
second. Press and hold down
the keys for at least 2 seconds
to move to the Protect Level.
To return to the Operation
Level, press the Level Key and
Mode Key together (
for at least 1 second.
 Moving to the Initial Setting Level
At the Operation Level, the main display part starts to flash when the Level Key (
at least 1 second. Press and hold down the keys for 2 more seconds to move to the Initial Setting
Level. To return to the Operation Level, press the Level Key (
 Moving to the Communications Setting Level
Press the Level Key (
Communications Setting Level. To return to the Initial Setting Level, press the Level Key (
less than 1 second). To return to the Operation Level, press the Level Key (
second.
After returning from any level to the Operation Level, the power ON reset process is always
executed to clear all measurement values and alarm outputs and return to the measurement
standby state.
Insulation Resistance Monitoring Device User's Manual (N224)
+
At least 1 second
+ )
Protect
Level
At least
Press
1 second
and hold
for at
least 2 TRIG
LVL
- 9#2
1
seconds
CH
MANU ERR
Note Power ON reset is a reset process that runs when the power turns ON.
+ )
) at the Initial Setting Level (for less than 1 second) to move to the
5 Using Setting Parameters
Power ON
Power ON
reset
At least 1 second
Operation
Level
+
At least
Press and hold
1 second
for at least 2
When When
seconds
the key is the key is
released released
FIN TRIG FIN
LVL
- 9#2
1
CH
AGE MANU ERR AGE
) for at least 1 second.
At least 1 second
Initial Setting
Level
Less than
1 second
Less than
1 second
Communications
Setting Level
) is pressed for
) (for
) for at least 1
TRIG FIN
----
1
CH
MANU ERR AGE
5 - 3
5