Omron K7GE-MG User Manual page 101

The following figure gives an overall image of the setting parameters.
+
Protect
Level
At least 1 second
p
LVL
wtpt
Setting Change
Protection
Note Power ON reset is a reset process that runs when
the power turns ON.
When moving to a level other than the Operation Level, the ALM 1 and ALM 2 output contacts turn OFF, regardless of
the setting value of the Alarm Polarity setting parameter.
When set to normally close, turning the output OFF has the same meaning as an alarm to external devices.
As an example of a countermeasure to this, provide a switch that can short-circuit the output contacts of the ALM 1 and
ALM 2 outputs, and use it to short-circuit the contacts during setting parameter operations and to release the short circuit
after returning to the Operation Level.
Insulation Resistance Monitoring Device User's Manual (N224)
Power ON
Power ON
reset
Operation Level
+
Measurement
At least ----
standby
3 seconds
93.2 After measurement
value confirmation
Each channel
5 Using Setting Parameters
Initial Setting
Level
At least 1 second
0
LVL
At least
Maximum
3 seconds
Number
mxch
of Channels
Alarm
alm1
Value 1
Alarm
alm2
Value 2
Alarm
nonc
Polarity
Trigger
tr-r
Signal
Reverse
Motor Stop
mtwt
Waiting Time
Time to Wait
stwt
to Stabilize
Average
avg
Processing
Use Running
age
Time
Software
v!0
Version
Communications
Setting Level
At least 1 second
1
LVL
Less than
1 second
psel
Protocol
Less than
Baud
bps
1 second
Rate
Data
len
Length
sbit
Stop Bits
prty
Parity
Send Wait
sdwt
Time
5 - 5
5