Table of Contents
Advertisement
Next steps
1.
Install the cooling fan
assembly.
2. Follow the procedure listed in
NVDIMM-N battery
NVDIMM-N battery details
NVDIMM-N battery can be installed on air shroud and 3.5-inch mid hard drive tray.
NOTE:
NVDIMM-N battery is not supported on 2.5 inch NVMe mid hard drive tray.
Removing the NVDIMM-N battery from the air shroud
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
CAUTION:
NVDIMM-N battery is not hot swappable. To prevent data loss and potential damage to your system, ensure
that your system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned off before removing
the NVDIMM-N battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
Steps
1. Disconnect the cables from the NVDIMM-N battery.
2. Using Phillips #2 screwdriver, remove the screw securing the NVDIMM-N battery.
3. Holding the edges, lift the NVDIMM-N battery at an angle to disengage it from the slot on the air shroud.
4. Lift the NVDIMM-N battery away from the system.
88
Installing and removing system components
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
