Table of Contents
Advertisement
Viewing System Setup
To view the System Setup screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
Related concepts
System Setup
on page 44
System Setup details
on page 45
System Setup details
The System Setup Main Menu screen details are explained as follows:
Option
Description
System BIOS
Enables you to configure BIOS settings.
iDRAC Settings
Enables you to configure the iDRAC settings.
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI (Unified
Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using the iDRAC settings
utility. For more information about this utility, see Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals.
Device Settings
Enables you to configure device settings.
Related concepts
System Setup
on page 44
iDRAC Settings utility
on page 67
Device Settings
on page 68
Related tasks
Viewing System Setup
on page 45
System BIOS
You can use the System BIOS screen to edit specific functions such as boot order, system password, and setup password, set the SATA
and PCIe NVMe RAID mode, and enable or disable USB ports.
Related concepts
System BIOS Settings details
Boot Settings
on page 52
Network Settings
on page 54
System Information
on page 47
Memory Settings
on page 48
Processor Settings
on page 49
SATA Settings
on page 51
Integrated Devices
on page 56
on page 46
Pre-operating system management applications
45
Advertisement
Table of Contents
