Hypertherm HyPrecision Predictive P-15 Operator's Manual page 222

9 – Installation
Pump Fault Behavior
Empty Dirty Water
Reminder
Reminder Time
Boost Fault
Monitor
Fan Fault Monitor
Seal Maintenance Indicator
For information about faults and warnings, refer to
Indicator On
Stop On Fault
Warning
Fault
Sleep
222
This turns the reminder feature on or off.
This timer determines how long the pump operates before the reminder is displayed.
The default is 200 hours.
The system can monitor an internal or external boost pump for fault conditions. This turns
monitoring on or off.
The system can monitor an external heat exchanger for fault conditions. This turns monitoring
on or off.
This turns the Seal Maintenance Indicator (SMI) on or off.
This turns the Stop On Fault feature on or off.
When this feature is on, the pump operates for 30 minutes after a fault is sensed and then turns off.
The Seal Maintenance Indicator senses leaks from the intensifier. This value determines the number
of units that cause a warning.
The default is 5 units.
This value determines the number of units that cause the system to turn off.
The default is 20 units.
If a fault occurs and the Stop On Fault feature is not on, this timer determines how long after a fault
is acknowledged that the system pauses before showing the
The default is 2.0 hours.
HyPrecision Predictive waterjet pump Operator Manual 810120
section, which begins on page 149.
Troubleshooting
Alarms
screen again.