Hypertherm HyPrecision Predictive P-15 Operator's Manual page 220

9 – Installation
Pressure Adjustments
Maximum
Increments
Increase
Decrease
Remote Configuration.
Analog Pressure
Modbus Mode
Modbus Pressure
IP Address
Netmask
Gateway
220
This is the maximum pressure that the system can be adjusted to.
The default is 4,140 bar (60,000 psi).
This is how much that the target pressure increases each time the + symbol on the primary
operation screen is touched.
The default is 34 bar (500 psi).
This is how much that the target pressure decreases each time the – symbol on the primary
operation screen is touched.
The default is 34 bar (500 psi).
This turns the remote analog pressure input on or off.
Turn Modbus mode on or off.
When this mode is on, the pump is controlled by Modbus TCP over Ethernet.
This turns Modbus control of the pump pressure on or off.
Enter a static IP address.
Enter the netmask.
Enter the gateway.
HyPrecision Predictive waterjet pump Operator Manual 810120