Operate The Pump - Hypertherm HyPrecision Predictive P-15 Operator's Manual

4 – Operation

Operate the pump

Run mode
Set the water pressure target
1. On the operator interface, touch these symbols to select pierce-pressure mode or cut-pressure mode.
2. There are 2 ways to change the water pressure target on the operator interface.
a. Touch the - symbol or the + symbol to change the water pressure target in preset increments.
The increments can be changed. Refer to Pressure Adjustments on page 220.
b. Touch the water pressure target field.
A numeric keypad opens.
HyPrecision Predictive waterjet pump Operator Manual 810120
1
1
Pierce-pressure mode (shown on)
2 Cut-pressure mode
2
65