Sensor Setting - Smartgen HGM7100N Series User Manual

11 SENSOR SETTING


When reselect sensors, the sensor curve will be transferred into the standard value. For example,
if temperature sensor is SGH (120° C resistor type), its sensor curve is SGH (120° C resistor type);
if select the SGD (120° C resistor type), the temperature sensor curve is SGD curve.

When there is difference between standard sensor curves and using sensor, user can adjust it in
"curve type".

When input the sensor curve, X value (resistor) must be input from small to large, otherwise,
mistake occurs.

If sensor is select as "Not Used", sensor curve will not work.

The corresponding sensor must configured as "Not Used"if sensor only has alarm switch,
otherwise, alarm shutdown or warning may occur.

The headmost or backmost values in the vertical coordinates can be set as same as below,
Items
1Pa
2
1kgf/cm
1bar
1psi
HGM7100N Genset Controller
Fig. 4 – Curve Setting
Table 15 - Common unit conversion table
2
N/m (pa)
1 1.02x10
4
9.8x10
5
1x10
3
6.89x10 7.03x10
2020-09-10
HGM7100N GENSET CONTROLLER USER MANUAL
2
kgf/cm
－
5
1x10
1
1.02
－
2
6.89x10
Version1.2
bar (p/in
－
5
1.45x10
0.98 14.2
1 14.5
－
2
Page 41 of 47
2
.psi)
－
4
1